Appliance Help HQ
Menu
ENEnglishESEspañolPT-BRPortuguês

Source-backed error-code guide

Reviewed

Amana Dishwasher F9 E1 / F9 E2 Error Code

Amana documents F9E1 and F9E2 as related drain faults. Owner-safe checks overlap around the accessible filter, drain hose, air gap, disposer connection, and excessive suds, while a persistent code needs service rather than pump replacement by guesswork.

Applies to Amana dishwasher

What the appliance detected

Detected condition

The dishwasher reports a drain-performance problem: F9 E1 for long drain/not draining, or F9 E2 for a drain-motor error.

What may contribute

Possible causes

  • The removable filter or visible drain path may be restricted.
  • The drain hose may be kinked, pinched, or clogged.
  • A disposer knockout plug, air gap, or excessive suds may interfere with drainage.
  • A persistent drain-motor/control condition may require internal diagnosis.

Start conservatively

Safe preliminary checks

Work in order and stop whenever a step is not supported by the documentation for your model.

  1. Record the code and model

    • Photograph or write down the exact code or flashing pattern before clearing it.
    • Confirm the full model number and Amana owner manual before taking model-specific action.

  2. Use only documented owner-safe checks

    • Clean the removable filter if the model manual identifies it as owner-accessible.
    • Check the visible drain hose for kinks or obvious restriction and inspect the air gap if the installation uses one.
    • If connected to a newly installed garbage disposer, confirm the disposer knockout plug was removed by the installer or a qualified person.
    • If excessive suds are present, stop the cycle and correct detergent use before retrying.

  3. Stop before internal work

    • If the code remains after the documented external checks, request service.
    • Do not remove panels, bypass door or float protections, or access wiring, pumps, valves, motors, controls, or heater circuits.

Actions not recommended

  • Do not reach into wet areas while electrical power is connected.
  • Do not remove service panels or probe energized wiring, pumps, valves, motors, controls, or heater circuits.
  • Do not replace a part based only on the displayed code.

When to stop and request service

  • F9 E1 or F9 E2 returns after accessible drain-path checks.
  • Standing water cannot be addressed safely or leaking is present.
  • Drain-pump, internal hose, wiring, or control diagnosis would be required.

Documented source

Official information reviewed

Our summary is based on manufacturer support material and stays within the limits of that material.

Source reviewed by Appliance Help HQ: September 23, 2026.

Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Amana.

Think this information has changed? Report a correction.