Appliance Help HQ
Menu
ENEnglishESEspañolPT-BRPortuguês

Source-backed error-code guide

Reviewed

Amana Range F6 E3 / F6E3 / E3 F6 / E3F6 Error Code

F6 E3 is an Appliance Manager or associated-wiring fault family. Amana notes there are multiple reasons it can occur, so the display is not a parts diagnosis.

Applies to Amana range using the documented F6 E3 display

What the appliance detected

Detected condition

Amana says there may be a problem with the Appliance Manager or associated wiring.

What may contribute

Possible causes

  • A possible Appliance Manager condition.
  • A possible associated-wiring condition or another cause within the documented fault family.

Start conservatively

Safe preliminary checks

Work in order and stop whenever a step is not supported by the documentation for your model.

  1. Record the exact code and model

    • Photograph or write down the complete F6 E3 display before clearing it.
    • Confirm the full model number because Amana code behavior can vary by range or oven model.

  2. Use one documented power reset if conditions are otherwise normal

    • If there is no smoke, sparking, burning smell, gas odor, uncontrolled heating, visible damage, or repeated breaker trip, turn the supplying circuit breaker off for one minute and restore power.
    • Monitor the oven for one minute. Do not repeat the reset if the code returns.

  3. Escalate a returning code

    • If the code reappears after the single reset, stop normal troubleshooting and request qualified appliance service.
    • Share the exact code, full model number, and whether the code returned immediately or during operation.

Actions not recommended

  • Do not remove panels or access control boards, harnesses, connectors, terminal blocks, or internal wiring.
  • Do not perform live-voltage, continuity, resistance, or gas-system testing as a homeowner troubleshooting step.
  • Do not replace a control, wiring harness, sensor, switch, latch, or other part solely because this display code appears.

When to stop and request service

  • F6 E3 returns after the single documented reset.
  • The range does not resume normal operation after power is restored.
  • Stop using the appliance and seek qualified help for smoke, sparking, a burning smell, uncontrolled heating, repeated breaker trips, visible electrical damage, or abnormal heat. If you smell gas, leave the area and follow local gas-emergency guidance rather than operating switches.

Documented source

Official information reviewed

Our summary is based on manufacturer support material and stays within the limits of that material.

Source reviewed by Appliance Help HQ: September 24, 2026.

Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Amana.

Think this information has changed? Report a correction.