Appliance Help HQ
Menu
ENEnglishESEspañolPT-BRPortuguês

Source-backed error-code guide

Reviewed

Amana Range F9 / F9 E0 / F9E0 / E0 F9 / E0F9 Error Code

F9/F9 E0 deserves electrician-first caution. A recent power outage can produce the code, but a persistent display on a new or existing installation can point to an electrical-supply problem that should not be opened or rewired by the homeowner.

Applies to Amana electric range using the documented F9 or F9 E0 display

What the appliance detected

Detected condition

The range control detected a power-supply condition it could not accept; Amana warns that persistent F9/F9 E0 can indicate a miswired outlet or electrical connection.

What may contribute

Possible causes

  • A recent power outage or power-up disturbance may have produced an incorrect-voltage detection.
  • The home outlet or appliance electrical connection may be miswired and require a qualified electrician.

Start conservatively

Safe preliminary checks

Work in order and stop whenever a step is not supported by the documentation for your model.

  1. Record the code, model, and timing

    • Photograph F9 or F9 E0 and note whether it followed a new installation, electrical work, or power outage.
    • Do not remove the terminal-block cover, receptacle, cord connection, or appliance panels.

  2. Use one reset only after a recent outage if there are no danger signs

    • If the code appeared after a power outage and there is no smoke, sparking, burning smell, visible damage, abnormal heat, or repeated breaker trip, turn the supplying breaker off for one minute and restore power.
    • Monitor the range for one minute. Do not keep cycling power if F9/F9 E0 returns.

  3. Use a qualified electrician for a persistent or installation-related code

    • If the range was installed recently or F9/F9 E0 persists, disconnect power and have a qualified electrician verify the electrical supply as Amana directs.
    • Do not attempt terminal-block, outlet, branch-circuit, or supply-voltage diagnosis from this guide.

Actions not recommended

  • Do not open the terminal block, receptacle, junction box, cord connection, or appliance panels.
  • Do not measure supply voltage or alter branch-circuit, cord, plug, neutral, ground, or hardwire connections unless you are qualified to perform that work.
  • Do not repeatedly reset and use the range if F9/F9 E0 returns.

When to stop and request service

  • F9/F9 E0 returns after one outage-related reset or appears on a recently installed range.
  • A qualified electrician verifies the supply is correct but the range still reports the code.
  • Stop using the appliance and seek qualified help for smoke, sparking, a burning smell, uncontrolled heating, repeated breaker trips, visible electrical damage, or abnormal heat. If you smell gas, leave the area and follow local gas-emergency guidance rather than operating switches.

Documented source

Official information reviewed

Our summary is based on manufacturer support material and stays within the limits of that material.

Source reviewed by Appliance Help HQ: September 24, 2026.

Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Amana.

Think this information has changed? Report a correction.