What the appliance detected
Detected condition
The washer motor cannot achieve the speed expected for the selected cycle.
What may contribute
Possible causes
- Shipping bolts or spacers may still be installed.
- The load may be too large or unable to tumble freely.
- A motor, sensor, wiring, drive, or control issue may require model-specific diagnosis.
Start conservatively
Safe preliminary checks
Work in order and stop whenever a step is not supported by the documentation for your model.
Check installation history
- If the washer is new or recently moved, confirm all shipping bolts and spacers were removed exactly as the installation instructions require.
- Do not operate the washer if shipping hardware remains installed.
Reduce the load and reset once
- Remove enough items for laundry to tumble freely and redistribute bulky items.
- If the washer is otherwise safe, use the documented cancel/power sequence or five-minute power disconnect for the exact model.
Actions not recommended
- Do not remove the motor, drive components, or control board from this code alone.
- Do not run repeated high-speed cycles while the drum binds, strikes the cabinet, or shipping hardware remains installed.
- Do not probe live motor or inverter circuits.
When to stop and request service
- F7 E1 returns after shipping hardware and load size are ruled out.
- The drum binds, grinds, strikes the cabinet, or cannot turn normally.
- The next step requires internal motor, speed-sensor, wiring, drive, or control diagnosis.
Documented source
Official information reviewed
Our summary is based on manufacturer support material and stays within the limits of that material.
Amana Product Help
Error Codes in Front Load WashersAmana Product Help
F7 E1 - Front Load Washer
Source reviewed by Appliance Help HQ: September 23, 2026.
Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Amana.
Think this information has changed? Report a correction.