Appliance Help HQ
Menu
ENEnglishESEspañolPT-BRPortuguês

Source-backed error-code guide

Reviewed

Bosch Dishwasher E0110 Error Code

Bosch describes E0110 as a failure causing electronics miscommunication and directs owners to Bosch Customer Support. The current Bosch error-code page does not publish a homeowner repair or reset procedure for E0110.

Applies to Bosch dishwasher whose exact model documentation uses the listed display

What the appliance detected

Detected condition

The dishwasher reports an internal electronics-miscommunication failure.

What may contribute

Possible causes

  • The dishwasher detected an internal electronics communication fault condition.
  • The Bosch code description does not identify one specific board, connector, wire, or network feature as the cause.

Start conservatively

Safe preliminary checks

Work in order and stop whenever a step is not supported by the documentation for your model.

  1. Record the exact display and model

    • Photograph E0110 before clearing the display and confirm every character.
    • Record the full Bosch E-Nr / model number because code meanings and supported reset procedures can vary by series.

  2. Use only Bosch-documented owner checks

    • Record any other code or unusual behavior that appears with E0110 and have the full E-Nr ready for Bosch support.
    • Do not assume that resetting a router, re-pairing Home Connect, or replacing a control board will correct E0110 unless the exact model documentation or Bosch support instructs it.

  3. Stop at the service boundary

    • If the code remains or returns after the documented check, contact Bosch Customer Support or qualified appliance service.
    • Do not pull the dishwasher apart to reach pumps, fans, heaters, spray-arm drives, control boards, sensors, wiring, or other internal components.

Actions not recommended

  • Do not test live voltage, remove electrical covers, or access the control board.
  • Do not bypass door, leak, heater, motor, or other safety controls.
  • Do not replace a fan, heat pump, spray-arm drive, sensor, wiring harness, or control board from the code alone.

When to stop and request service

  • E0110 is displayed.
  • The dishwasher will not start, complete a cycle, or respond normally.
  • Any board, connector, wiring, software, or internal communication diagnosis is required.

Documented source

Official information reviewed

Our summary is based on manufacturer support material and stays within the limits of that material.

Source reviewed by Appliance Help HQ: September 22, 2026.

Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Bosch.

Think this information has changed? Report a correction.