What the appliance detected
Detected condition
The dryer is indicating or using an Auto Dry setting.
What may contribute
Possible causes
- Auto Dry may be the selected drying mode.
- The display may be showing a cycle/status abbreviation rather than a fault.
- Confusion can happen when AD appears in the same area where other dryers show fault codes.
Start conservatively
Safe preliminary checks
Work in order and stop whenever a step is not supported by the documentation for your model.
Check the selected cycle
- Review the control panel and confirm whether Auto Dry is selected.
- Compare the display with the exact model owner guide because labels and cycle behavior vary.
Run a normal load if operation is otherwise normal
- If there are no safety symptoms or separate error codes, use the dryer normally with the correct fabric/cycle settings.
- If drying performance is poor, troubleshoot the drying symptom separately rather than treating AD as a failed part.
Actions not recommended
- Do not replace a sensor, heater, or control simply because AD is displayed.
- Do not enter service modes or remove panels to clear a normal Auto Dry indication.
When to stop and request service
- The dryer also shows a separate fault code or has a distinct symptom such as no heat, overheating, or failure to start.
- The control panel does not match the model guide or cannot select/exit cycles normally.
Documented source
Official information reviewed
Our summary is based on manufacturer support material and stays within the limits of that material.
Electrolux Owner Support
Laundry Dryer Error Code Guide
Source reviewed by Appliance Help HQ: September 23, 2026.
Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Electrolux.
Think this information has changed? Report a correction.