Appliance Help HQ
Menu
ENEnglishESEspañolPT-BRPortuguês

Source-backed error-code guide

Reviewed

Electrolux Washer E35 Error Code

Electrolux describes E35 as a water-overfill condition. Because active overfilling can become a water-and-electricity hazard, stop repeated testing and use only the manufacturer-documented cancel/reset steps after the situation is safe.

Applies to Electrolux front-load washer using E35 for an overfill condition

What the appliance detected

Detected condition

The washer detected or reported an overfill condition.

What may contribute

Possible causes

  • A recent installation or move may have left an installation problem.
  • The washer may be reporting an abnormal water-level or overfill condition.
  • If water continues entering or E35 returns, internal water-level, inlet, wiring, or control diagnosis may be needed.

Start conservatively

Safe preliminary checks

Work in order and stop whenever a step is not supported by the documentation for your model.

  1. Treat active overfill as a stop-use condition

    • If water is actively overflowing or approaching electrical areas, stop the cycle and close the household water supplies if they are safely reachable.
    • Disconnect power only if you can do so without stepping into water or touching wet electrical equipment.

  2. Record E35 and installation context

    • Photograph E35 and note whether the washer was recently installed or moved.
    • If it is a recent installation, have the installer verify the setup as Electrolux recommends.

  3. Use only one documented reset after the condition is safe

    • Electrolux documents pressing Cancel to clear E35 and a hard reset by disconnecting and reconnecting AC power.
    • Do not repeat resets if the washer begins overfilling again or the code returns.

Actions not recommended

  • Do not keep operating a washer that is actively overfilling.
  • Do not remove panels or test pressure sensors, inlet valves, wiring, or live voltage.
  • Do not replace a pressure sensor or control board based on E35 alone.

When to stop and request service

  • E35 returns after a safe documented reset and the installation is confirmed.
  • Water keeps entering, the washer overflows, or any leak reaches electrical areas.
  • Internal water-level, inlet-valve, wiring, or control diagnosis is required.

Documented source

Official information reviewed

Our summary is based on manufacturer support material and stays within the limits of that material.

Source reviewed by Appliance Help HQ: September 23, 2026.

Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Electrolux.

Think this information has changed? Report a correction.