Appliance Help HQ
Menu
ENEnglishESEspañolPT-BRPortuguês

Source-backed error-code guide

Reviewed

Electrolux washer LOC Status Message

LOC is a control-lock status message on supported Electrolux washers, not a component-failure diagnosis. Electrolux says cycles will not run while Control Lock is active.

Applies to Electrolux front-load washer using LOC for Control Lock

What the appliance detected

Detected condition

Control Lock is active and normal cycle controls are intentionally locked.

What may contribute

Possible causes

  • Control Lock was intentionally enabled.
  • The feature may have been activated accidentally while navigating the controls.
  • If LOC cannot be cleared with the model-supported procedure, the control system may need service.

Start conservatively

Safe preliminary checks

Work in order and stop whenever a step is not supported by the documentation for your model.

  1. Confirm the display says LOC

    • Photograph the display and confirm the exact model number.
    • Do not confuse LOC with a different lock or service code on another platform.

  2. Use the documented Control Lock menu

    • Electrolux documents scrolling to the Control Lock option and pressing Select on supported models.
    • If your control panel does not match that description, use the exact model manual instead of guessing a button combination.

  3. Confirm normal controls return

    • After Control Lock is disabled, confirm the lock icon/message clears and normal cycle selection is available.
    • If controls remain unresponsive, stop repeating button combinations and request model-specific support.

Actions not recommended

  • Do not bypass a door lock, lid lock, or other safety interlock to clear LOC.
  • Do not remove the console or test internal control wiring.
  • Do not replace a control board because LOC is displayed while Control Lock is enabled.

When to stop and request service

  • LOC cannot be cleared using the model-supported Control Lock procedure.
  • The controls remain unresponsive after the lock status is cleared.
  • Console, wiring, or control diagnosis would be required.

Documented source

Official information reviewed

Our summary is based on manufacturer support material and stays within the limits of that material.

Source reviewed by Appliance Help HQ: September 23, 2026.

Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Electrolux.

Think this information has changed? Report a correction.