What the appliance detected
Detected condition
The control is not receiving the expected room-temperature thermistor signal.
What may contribute
Possible causes
- A temporary control or sensor communication state may clear after one power reset.
- The room-temperature thermistor, its wiring, connection, or control circuit may need model-specific diagnosis.
- Cabinet temperature or cooling performance cannot be diagnosed from AS alone.
Start conservatively
Safe preliminary checks
Work in order and stop whenever a step is not supported by the documentation for your model.
Record the code and exterior conditions
- Photograph or note AS before resetting the unit and note whether the unit was cooling, starting, or recently moved.
- Make sure curtains, furniture, or covers are not blocking the front or rear airflow openings.
Use Frigidaire’s single power reset
- Turn the unit off and unplug it from the power source for up to 30 seconds.
- Plug it back in and operate it normally. If AS returns, stop repeated resets and arrange service.
Actions not recommended
- Do not remove the cabinet to locate or test the thermistor.
- Do not jumper a sensor, probe live wiring, or replace a control based only on AS.
- Do not bypass or modify the safety plug or grounding connection.
When to stop and request service
- AS returns after the documented reset.
- Cooling becomes unreliable or the display shows implausible temperature behavior.
- Diagnosis would require internal sensor, wiring, connector, or control access.
Documented source
Official information reviewed
Our summary is based on manufacturer support material and stays within the limits of that material.
Frigidaire
Room Air Conditioners - Error Code Guide
Source reviewed by Appliance Help HQ: September 23, 2026.
Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Frigidaire.
Think this information has changed? Report a correction.