What the appliance detected
Detected condition
The dishwasher detected a fault in the heating-function category.
What may contribute
Possible causes
- A temporary control state may clear after a power cycle.
- A heater, temperature-sensing, wiring, control, or related internal condition may need service.
- The code does not prove that the heating element itself is defective.
Start conservatively
Safe preliminary checks
Work in order and stop whenever a step is not supported by the documentation for your model.
Record the code and cycle context
- Photograph F4 E3 and note whether the code appeared during washing, drying, or after a recent power interruption.
- Stop immediately for burning odor, smoke, unusual heat, or a breaker trip.
Use one documented power cycle
- Disconnect power for 30 seconds if the dishwasher is dry externally and there are no electrical warning signs.
- Restore power and try normal operation once. If F4 E3 returns, request service.
Actions not recommended
- Do not access or test the heater, temperature sensors, high-limit devices, wiring, or controls.
- Do not measure live voltage or resistance inside the dishwasher.
- Do not keep using a dishwasher that smells burned or overheats.
When to stop and request service
- F4 E3 returns after one documented reset.
- There is burning odor, smoke, abnormal heat, repeated breaker tripping, or water near electrical parts.
- Internal heater, sensor, harness, or control diagnosis is required.
Documented source
Official information reviewed
Our summary is based on manufacturer support material and stays within the limits of that material.
JennAir Product Help
F4E3 - Dishwasher
Source reviewed by Appliance Help HQ: September 24, 2026.
Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by JennAir.
Think this information has changed? Report a correction.