What the appliance detected
Detected condition
The control detected a wash-motor operating fault.
What may contribute
Possible causes
- A temporary control state may clear after one power cycle.
- The wash motor, its electrical path, control, or another internal condition may require model-specific diagnosis.
- F7 E2 does not identify the exact failed part.
Start conservatively
Safe preliminary checks
Work in order and stop whenever a step is not supported by the documentation for your model.
Record the exact code and symptoms
- Photograph F7 E2 and note whether the dishwasher stopped washing, became unusually quiet, or displayed another code.
- Check for active leakage, burning odor, or repeated breaker trips before resetting power.
Use one JennAir power cycle
- Disconnect dishwasher power for 30 seconds using the plug or normal breaker if safely accessible.
- Restore power and try normal operation once. If F7 E2 returns, stop and schedule service.
Actions not recommended
- Do not remove the circulation motor, sump, lower panels, or electrical covers.
- Do not test motor resistance or live voltage as a homeowner step.
- Do not replace the wash motor solely because F7 E2 appears.
When to stop and request service
- F7 E2 returns after one documented power cycle.
- The dishwasher leaks, trips a breaker, smells burned, or makes abnormal mechanical noise.
- Diagnosis requires wash-motor, wiring, control, or internal hydraulic access.
Documented source
Official information reviewed
Our summary is based on manufacturer support material and stays within the limits of that material.
JennAir Product Help
F7E2 - DishwasherJennAir Product Help
Dishwasher Error Codes - Reading
Source reviewed by Appliance Help HQ: September 24, 2026.
Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by JennAir.
Think this information has changed? Report a correction.