What the appliance detected
Detected condition
The electronic oven control cannot recognize what type of problem has occurred.
What may contribute
Possible causes
- A control-system fault may be present.
- The electronic control or associated internal wiring may be involved.
- A temporary control state may clear after one manufacturer-documented power reset.
Start conservatively
Safe preliminary checks
Work in order and stop whenever a step is not supported by the documentation for your model.
Record the code and model
- Photograph F0 E0 before clearing it and record the full model number.
- Note what the oven was doing when the code appeared.
Reset once
- Turn the supplying breaker off for one minute, restore power, and monitor the oven for one minute as JennAir directs.
- If the code returns, stop resetting and request service.
Actions not recommended
- Do not remove the control panel or probe internal wiring.
- Do not perform live-voltage, resistance, or continuity tests.
- Do not replace a control board from F0 E0 alone.
When to stop and request service
- F0 E0 returns after one reset.
- Controls are erratic or the oven heats unexpectedly.
- Any smoke, sparking, burning odor, gas odor, or repeated breaker trip occurs.
Documented source
Official information reviewed
Our summary is based on manufacturer support material and stays within the limits of that material.
JennAir Product Help
F0 E0 - Error Code - Range
Source reviewed by Appliance Help HQ: September 24, 2026.
Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by JennAir.
Think this information has changed? Report a correction.