What the appliance detected
Detected condition
The dishwasher reports a user-interface or main-control error condition.
What may contribute
Possible causes
- The dishwasher detected a user-interface or main-control fault condition.
- A temporary control state may clear after one documented power cycle.
- Persistent interface, harness, connector, or main-control issues require service.
Start conservatively
Safe preliminary checks
Work in order and stop whenever a step is not supported by the documentation for your model.
Record the code and button behavior
- Photograph F6 E1 and record the full model number.
- Note whether the display and buttons respond normally before clearing the code.
Power-cycle the control once
- Disconnect dishwasher power for 30 seconds using the normal plug or dedicated breaker.
- Restore power and check whether the controls respond normally.
Escalate a returning control code
- If F6 E1 returns or the controls remain unresponsive, request service.
- Do not keep cycling power to mask a repeating control problem.
Actions not recommended
- Do not remove the console or access control boards, wiring, or connectors.
- Do not bypass the door latch or interlock while testing controls.
- Do not replace the user interface or main control from F6 E1 alone.
When to stop and request service
- F6 E1 returns after one documented power cycle.
- The display or controls remain unresponsive or behave erratically.
- Internal user-interface, harness, connector, or main-control diagnosis is needed.
Documented source
Official information reviewed
Our summary is based on manufacturer support material and stays within the limits of that material.
KitchenAid Product Help
F6E1 - DishwasherKitchenAid Product Help
Dishwasher Error Codes - Reading
Source reviewed by Appliance Help HQ: September 23, 2026.
Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by KitchenAid.
Think this information has changed? Report a correction.