Appliance Help HQ
Menu
ENEnglishESEspañolPT-BRPortuguês

Source-backed error-code guide

Reviewed

KitchenAid Microwave F6 Error Code

F6 is an electronic execution/control fault on supported over-the-range microwaves. Because the relay board and wiring are internal, the homeowner-safe workflow is limited to code/model confirmation and one power reset.

Applies to KitchenAid over-the-range microwave with an applicable electronic display

What the appliance detected

Detected condition

KitchenAid says F6 can occur when the oven cannot execute a function and may involve the relay control board or associated wiring.

What may contribute

Possible causes

  • The relay control board may not have executed the requested function.
  • Associated internal wiring or connectors may require professional diagnosis.
  • Another electronic control condition may be preventing normal execution.

Start conservatively

Safe preliminary checks

Work in order and stop whenever a step is not supported by the documentation for your model.

  1. Record the exact code and model first

    • Photograph or write down the complete display before resetting it: F6.
    • Confirm the full KitchenAid model number and whether the appliance is over-the-range or built-in. KitchenAid code meanings can vary by product family.

  2. Try the KitchenAid power reset once, only when conditions are safe

    • If there is no smoke, burning odor, arcing, unusual overheating, visible damage, active water intrusion, or repeated breaker trip, disconnect power at the plug or breaker for one minute.
    • Restore power once and monitor the display. If the code returns, stop using the microwave and request qualified service rather than repeating resets.

Actions not recommended

  • Do not remove the outer cabinet, control panel, vent housing, waveguide cover, or any microwave service panel.
  • Do not touch or test the high-voltage capacitor, transformer, inverter, magnetron, internal fuses, relays, thermistors, sensors, interlock wiring, or control boards. Dangerous voltage can remain after power is disconnected.
  • Do not perform live-voltage, resistance, continuity, capacitor-discharge, or internal connector testing as a homeowner troubleshooting step.
  • Do not bypass, tape, bridge, defeat, or adjust a door-interlock switch, and do not operate a microwave with a damaged or misaligned door.
  • Do not replace a board, sensor, thermistor, relay, switch, or wiring harness from the display code alone.

When to stop and request service

  • Request qualified microwave service if the code returns after the single KitchenAid power reset.
  • Leave the appliance powered off and seek service immediately for smoke, a burning odor, repeated arcing, abnormal overheating, a damaged door, visible wiring damage, water near electrical parts, or repeated breaker trips.

Documented source

Official information reviewed

Our summary is based on manufacturer support material and stays within the limits of that material.

Source reviewed by Appliance Help HQ: September 24, 2026.

Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by KitchenAid.

Think this information has changed? Report a correction.