Appliance Help HQ
Menu
ENEnglishESEspañolPT-BRPortuguês

Source-backed error-code guide

Reviewed

KitchenAid Range F2 E1 Error Code

F2 E1 is a control/keypad family fault on supported KitchenAid ranges. The manufacturer supports checking normal exterior conditions and one documented power reset; persistent faults belong with service.

Applies to KitchenAid range or wall oven using the documented display family

What the appliance detected

Detected condition

KitchenAid says there may be a problem involving the user interface or keypad, the control, or associated wiring.

What may contribute

Possible causes

  • A user-interface or keypad problem may be present.
  • The electronic control or associated wiring may be involved.
  • On the current KitchenAid range support page, grate installation is also listed as an exterior condition to verify before resetting on applicable models.

Start conservatively

Safe preliminary checks

Work in order and stop whenever a step is not supported by the documentation for your model.

  1. Record the code and inspect only normal exterior conditions

    • Photograph F2 E1 and record the complete model number.
    • If the model has removable grates, wait until everything is cool and verify they are seated level and in their normal positions.

  2. Check the control surface without opening it

    • Make sure no key is physically held down by cookware, a cover, or obvious debris.
    • Clean only according to the owner manual and never flood the control panel with liquid.

  3. Power-cycle once

    • Turn off the supplying breaker for one minute, restore power, and monitor for one minute as KitchenAid documents.
    • If F2 E1 returns, stop repeating resets and request service.

Actions not recommended

  • Do not pry keys, open the user interface, or remove the control panel.
  • Do not probe wiring or perform live-voltage, resistance, or continuity tests.
  • Do not replace a keypad or control from F2 E1 alone.

When to stop and request service

  • F2 E1 returns after one documented reset.
  • Controls are unresponsive, erratic, or unsafe to operate.
  • The next step would require user-interface, control, or wiring diagnosis.

Documented source

Official information reviewed

Our summary is based on manufacturer support material and stays within the limits of that material.

Source reviewed by Appliance Help HQ: September 23, 2026.

Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by KitchenAid.

Think this information has changed? Report a correction.