What the appliance detected
Detected condition
A Maytag dishwasher display using F7 E2 reports a wash-motor error.
What may contribute
Possible causes
- The control detected a wash-motor fault condition.
- Maytag does not list a safe external repair for this code beyond a power cycle.
Start conservatively
Safe preliminary checks
Work in order and stop whenever a step is not supported by the documentation for your model.
Record the code and model
- Photograph or write down the exact code or flashing pattern before clearing it.
- Confirm the full model number and Maytag owner manual before taking model-specific action.
Use only documented external checks
- Disconnect dishwasher power for 30 seconds as Maytag documents for a control power cycle.
- Restore power once and check whether normal operation resumes.
Stop before internal work
- If the code remains after documented checks, request service.
- Do not remove panels, bypass switches, or access wiring, motors, pumps, controls, or heater circuits.
Actions not recommended
- Do not reach into wet areas while power is connected.
- Do not open electrical, motor, pump, heater, or control areas.
- Do not replace parts based only on the displayed code.
When to stop and request service
- F7 E2 returns after one documented power cycle.
- The dishwasher will not run normally.
- Motor, wiring, or control diagnosis would be required.
Documented source
Official information reviewed
Our summary is based on manufacturer support material and stays within the limits of that material.
Maytag Product Help
Dishwasher Error Codes - Reading
Source reviewed by Appliance Help HQ: August 17, 2026.
Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Maytag.
Think this information has changed? Report a correction.