What the appliance detected
Detected condition
A Maytag dishwasher display using H2O means the appliance is not detecting water.
What may contribute
Possible causes
- The dishwasher water supply may be turned off.
- The visible water supply hose may be kinked.
Start conservatively
Safe preliminary checks
Work in order and stop whenever a step is not supported by the documentation for your model.
Record the code and model
- Photograph or write down the exact code or flashing pattern before clearing it.
- Confirm the full model number and Maytag owner manual before taking model-specific action.
Use only documented external checks
- Confirm the dishwasher water supply is turned on.
- Check the visible water supply hose for kinks.
- After the supply issue is corrected, press Start so the dishwasher can attempt to fill and resume the cycle.
Stop before internal work
- If the code remains after documented checks, request service.
- Do not remove panels, bypass switches, or access wiring, motors, pumps, controls, or heater circuits.
Actions not recommended
- Do not reach into wet areas while power is connected.
- Do not open electrical, motor, pump, heater, or control areas.
- Do not replace parts based only on the displayed code.
When to stop and request service
- H2O remains after the supply is on and visible hose kinks are corrected.
- There is leaking or water damage.
- Valve, wiring, pressure, or internal diagnosis would be required.
Documented source
Official information reviewed
Our summary is based on manufacturer support material and stays within the limits of that material.
Maytag Product Help
Dishwasher Error Codes - ReadingMaytag Product Help
H2O - Dishwasher
Source reviewed by Appliance Help HQ: August 17, 2026.
Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Maytag.
Think this information has changed? Report a correction.