Appliance Help HQ
Menu
ENEnglishESEspañolPT-BRPortuguês

Source-backed error-code guide

Reviewed

Whirlpool Dishwasher F6 E1 Error Code

Whirlpool lists F6 E1 as a user-interface error or main-control condition. The published homeowner guidance is a power cycle followed by service if the error returns.

Applies to Whirlpool dishwasher

What the appliance detected

Detected condition

The dishwasher reports a user-interface or main-control error.

What may contribute

Possible causes

  • The control detected a user-interface or main-control fault condition.
  • The available source does not provide a safe homeowner component repair.

Start conservatively

Safe preliminary checks

Work in order and stop whenever a step is not supported by the documentation for your model.

  1. Record the display

    • Write down F6 E1 or F6E1 and the model number.
    • Note whether the controls respond normally.

  2. Power cycle once

    • Disconnect power to the dishwasher for one minute.
    • Restore power and check whether the code returns.

  3. Preserve a returning code

    • If F6 E1 returns, request service.
    • Avoid repeated resets that erase useful diagnostic context.

Actions not recommended

  • Do not open the console or control areas.
  • Do not access wiring or circuit boards.
  • Do not treat F6 E1 as proof that a particular board needs replacement.

When to stop and request service

  • F6 E1 returns after one documented power cycle.
  • Controls remain unresponsive.
  • Internal electrical diagnosis would be needed.

Documented source

Official information reviewed

Our summary is based on manufacturer support material and stays within the limits of that material.

Source reviewed by Appliance Help HQ: August 17, 2026.

Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Whirlpool.

Think this information has changed? Report a correction.