Appliance Help HQ
Menu
ENEnglishESEspañolPT-BRPortuguês

Source-backed error-code guide

Reviewed

Amana Microwave F6 / F6 E0 / F7 / F9 Error Code

These codes share the same owner-safe boundary: the microwave could not execute a function and the affected internal control path requires professional diagnosis if one Amana power reset does not clear the display.

Applies to Amana over-the-range microwave with an applicable electronic display

What the appliance detected

Detected condition

Amana documents F6 as a relay-control execution fault, F6 E0 and F7 as appliance-control execution faults, and F9 as an execution fault that may involve the appliance control board, relay control board, or associated wiring.

What may contribute

Possible causes

  • The appliance or relay control electronics may not be executing the requested function normally.
  • Associated internal wiring or connectors may require professional diagnosis.
  • Another internal electronic condition may be preventing the requested function from completing.

Start conservatively

Safe preliminary checks

Work in order and stop whenever a step is not supported by the documentation for your model.

  1. Record the display and confirm the model

    • Photograph or write down the exact display before changing anything: F6, F6 E0, F7, F9.
    • Confirm the complete Amana model number and compare the display with the owner documentation for that exact microwave because code sets vary by platform.

  2. Try one Amana power reset

    • If there is no smoke, burning odor, repeated arcing, visible door damage, active water intrusion, severe overheating, or repeated breaker trip, switch the microwave circuit breaker off for one full minute.
    • Restore power once, monitor the display for at least one minute, and verify normal operation without opening the cabinet.
    • If the display returns, stop using the microwave and request qualified service rather than repeating resets.

Actions not recommended

  • Do not remove the outer cabinet, control panel, vent housing, waveguide cover, or any service panel to chase a display code.
  • Do not touch or test the high-voltage capacitor, transformer, inverter, magnetron, internal fuse, interlock wiring, control boards, sensors, thermistors, relays, or internal harnesses.
  • Do not bypass, tape, bridge, defeat, or adjust the door-interlock system, and do not operate the microwave with a damaged or misaligned door.
  • Do not perform live-voltage, continuity, resistance, capacitor-discharge, or internal connector tests as an owner troubleshooting step.
  • Do not replace a keypad, sensor, thermistor, control board, relay board, switch, or other internal part from a display code alone.

When to stop and request service

  • Request qualified microwave service if the display returns after the single Amana one-minute power reset.
  • Leave power disconnected and arrange service immediately for smoke, a burning odor, repeated arcing, a repeated breaker trip, visible door or wiring damage, or water near electrical parts.

Documented source

Official information reviewed

Our summary is based on manufacturer support material and stays within the limits of that material.

Source reviewed by Appliance Help HQ: September 24, 2026.

Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Amana.

Think this information has changed? Report a correction.