Appliance Help HQ
Menu
ENEnglishESEspañolPT-BRPortuguês

Source-backed error-code guide

Reviewed

Bosch Dryer E08 / E09 / E24 / E25 / E28 / E90 Error Code

Bosch groups E08, E09, E24, E25, E28, and E90 as electronics faults and says only an authorized technician can eliminate them. Bosch does not provide an internal homeowner procedure for this group.

Applies to Bosch dryer whose exact model documentation uses the listed display

What the appliance detected

Detected condition

The dryer reports an electronics fault or error.

What may contribute

Possible causes

  • The dryer has detected an electronics fault.
  • The specific control, sensor, communication, wiring, or power-related cause requires professional diagnosis.

Start conservatively

Safe preliminary checks

Work in order and stop whenever a step is not supported by the documentation for your model.

  1. Record the display and Bosch model

    • Photograph or write down E08 or E09 or E24 or E25 or E28 or E90 before clearing it.
    • Confirm the complete model number and owner manual because Bosch dryer displays and owner procedures vary by model and family.

  2. Use only Bosch-supported owner checks

    • Stop the cycle and record the exact displayed identifier and complete model number.
    • Do not remove panels, access a control board, press an internal reset, or test live voltage.
    • Contact Bosch support or an authorized service provider.

  3. Respect the dryer service boundary

    • Stop if a check would require removing a panel, reaching internal wiring, testing live voltage, or accessing a heating or gas system.
    • If the display remains or returns after the documented owner check, contact Bosch support or qualified dryer service.

Actions not recommended

  • Do not assume the display applies to another Bosch dryer without checking its exact manual.
  • Do not remove rear or service panels, press an internal reset, or bypass a control or safety device.
  • Do not test mains voltage, capacitors, controls, heating circuits, gas components, or internal wiring.

When to stop and request service

  • Any listed electronics code is displayed.
  • The display, controls, motor, heat, or cycle operation behaves abnormally.
  • Any internal electronic, control, sensor, wiring, motor, heating, or supply diagnosis is required.

Documented source

Official information reviewed

Our summary is based on manufacturer support material and stays within the limits of that material.

Source reviewed by Appliance Help HQ: August 25, 2026.

Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Bosch.

Think this information has changed? Report a correction.