What the appliance detected
Detected condition
Demo Mode is active, allowing controls to operate without normal cooking-zone heating.
What may contribute
Possible causes
- Demo Mode may still be enabled from display, delivery, or setup.
- The mode may have been enabled accidentally.
- If dE clears but heating does not return, a separate operating or service issue may exist.
Start conservatively
Safe preliminary checks
Work in order and stop whenever a step is not supported by the documentation for your model.
Confirm the exact dE display
- Photograph dE and confirm the model is an applicable Bosch induction slide-in range.
- Do not assume another D/E code means Demo Mode.
Follow Bosch Demo Mode exit timing
- Bosch directs owners to disconnect power at the breaker or fuse for 30 seconds and restore it.
- Within the next three minutes, touch any appliance control as Bosch documents.
Verify normal heating behavior
- After dE clears, test only normal cookware operation according to the owner manual.
- If heating does not return, stop repeating Demo Mode steps and troubleshoot the separate symptom.
Actions not recommended
- Do not enter undocumented service menus or hidden setup modes.
- Do not remove panels or test induction electronics because dE appears.
- Do not repeatedly cycle power if Demo Mode clears but heating remains abnormal.
When to stop and request service
- dE returns after the documented Demo Mode exit procedure.
- Cooking zones still do not heat normally with suitable cookware after the mode clears.
- Controls, induction electronics, or supply diagnosis beyond normal operation is required.
Documented source
Official information reviewed
Our summary is based on manufacturer support material and stays within the limits of that material.
Bosch Owner Support
Bosch Slide-in Range Error CodesBosch Owner Support
Bosch Error Codes
Source reviewed by Appliance Help HQ: September 23, 2026.
Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Bosch.
Think this information has changed? Report a correction.