What the appliance detected
Detected condition
A Maytag dishwasher display using F8 E4 reports water detected in the drip tray.
What may contribute
Possible causes
- Water may be present in the drip tray.
- A visible water connection may be leaking.
- Excess suds can also push water where it does not belong.
Start conservatively
Safe preliminary checks
Work in order and stop whenever a step is not supported by the documentation for your model.
Record the code and model
- Photograph or write down the exact code or flashing pattern before clearing it.
- Confirm the full model number and Maytag owner manual before taking model-specific action.
Use only documented external checks
- Turn off power before any wet-area cleanup.
- Check only visible, accessible water connections for leaks.
- If suds are present, stop the dishwasher and allow suds to dissipate; use only automatic-dishwasher detergent.
Stop before internal work
- If the code remains after documented checks, request service.
- Do not remove panels, bypass switches, or access wiring, motors, pumps, controls, or heater circuits.
Actions not recommended
- Do not reach into wet areas while power is connected.
- Do not open electrical, motor, pump, heater, or control areas.
- Do not replace parts based only on the displayed code.
When to stop and request service
- F8 E4 returns after visible water, leaks, or suds are addressed.
- A leak source is not obvious or internal access would be needed.
- Float-switch, wiring, or drip-tray access is not safely user-accessible.
Documented source
Official information reviewed
Our summary is based on manufacturer support material and stays within the limits of that material.
Maytag Product Help
Dishwasher Error Codes - Reading
Source reviewed by Appliance Help HQ: August 17, 2026.
Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Maytag.
Think this information has changed? Report a correction.