What the appliance detected
Detected condition
The water-filter status light indicates filter attention is needed.
What may contribute
Possible causes
- The water filter may be due for replacement.
- Water flow or ice production may decrease as the filter ages or clogs.
- The filter status may need resetting after a filter change.
Start conservatively
Safe preliminary checks
Work in order and stop whenever a step is not supported by the documentation for your model.
Record the display and model
- Photograph or write down the exact alert, word, or code before clearing it.
- Confirm the full model number and Maytag owner manual because controls vary by refrigerator family.
Use only documented external checks
- Replace the water filter according to the owner manual if it is due or flow is reduced.
- After changing the filter, reset the filter status using the model-specific documented controls.
- Use the correct filter specified for the model.
Stop before internal work
- If the alert remains after documented checks, request service.
- Do not open sealed-system, compressor, fan, sensor, wiring, or control areas.
Actions not recommended
- Do not perform refrigerant or sealed-system work.
- Do not test live voltage or open internal electrical areas.
- Do not replace compressor, fan, sensor, water-valve, or control parts based only on the display.
When to stop and request service
- Water flow or ice production remains poor after a correct filter replacement.
- The filter cannot be installed or reset normally.
- Internal water-line, valve, or dispenser diagnosis would be needed.
Documented source
Official information reviewed
Our summary is based on manufacturer support material and stays within the limits of that material.
Maytag Product Help
H2O Light - Side by Side Refrigerator
Source reviewed by Appliance Help HQ: August 17, 2026.
Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Maytag.
Think this information has changed? Report a correction.