What the appliance detected
Detected condition
The beverage center reports that internal temperature is too low.
What may contribute
Possible causes
- The door may not be fully closed or may have been open for an extended period.
- Room-temperature items may have been recently added.
- A recent power outage or temperature event may affect readings.
Start conservatively
Safe preliminary checks
Work in order and stop whenever a step is not supported by the documentation for your model.
Confirm the product type
- Record CL or LO and the complete model number.
- Use this guide only for a Whirlpool beverage center covered by the source guidance.
Check external conditions
- Make sure the door is fully closed.
- Note recent restocking with room-temperature items or a recent power outage.
Allow stabilization and reset only as documented
- Allow the unit to stabilize if recent use explains the alert.
- If needed, disconnect power for one minute and restore it, then request service if the alert continues.
Actions not recommended
- Do not adjust sealed-system or compressor components.
- Do not open electrical controls or test live parts.
- Do not treat CL or LO as proof of a failed thermostat or control.
When to stop and request service
- CL or LO continues after door, loading, stabilization, and one documented reset are addressed.
- The beverage center temperature remains outside a safe or intended range.
- Internal diagnosis would be required.
Documented source
Official information reviewed
Our summary is based on manufacturer support material and stays within the limits of that material.
Whirlpool Product Help
CL or LO Error Code - Beverage Center
Source reviewed by Appliance Help HQ: August 29, 2026.
Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Whirlpool.
Think this information has changed? Report a correction.