What the appliance detected
Detected condition
Water takes too long to drain or is not draining properly.
What may contribute
Possible causes
- Drain hose may be kinked or clogged.
- Standpipe height may be incorrect.
- The lid must be closed for spin operation.
Start conservatively
Safe preliminary checks
Work in order and stop whenever a step is not supported by the documentation for your model.
Record the code and model
- Photograph or write down the exact code before clearing it.
- Confirm whether the model is the top-load or front-load family covered by the official source.
Use only the documented external checks
- Check normal household fuse or breaker if the washer has no power.
- Close the lid and press Start/Pause.
- Straighten a visible kinked drain hose and compare standpipe height with the installation instructions.
Stop before internal repair
- If the code continues, request service or installer support as Frigidaire directs.
- Do not remove panels, bypass locks, or access internal wiring or controls.
Actions not recommended
- Do not bypass lid locks or safety controls.
- Do not access internal pumps, motors, valves, wiring, or circuit boards.
- Do not treat the code as proof that a specific part has failed.
When to stop and request service
- E2 remains after visible drain setup is corrected.
- Any pump, internal hose, wiring, or control diagnosis would be required.
Documented source
Official information reviewed
Our summary is based on manufacturer support material and stays within the limits of that material.
Frigidaire Owner Support
Laundry top loading washer displaying Error Code E2 water takes too long to drain
Source reviewed by Appliance Help HQ: August 17, 2026.
Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Frigidaire.
Think this information has changed? Report a correction.