What the appliance detected
Detected condition
The dishwasher reports a long-drain or not-draining condition.
What may contribute
Possible causes
- The filter may need cleaning.
- The drain hose may be kinked, pinched, or clogged.
- A disposer knockout plug or air gap may restrict draining on installations that use them.
Start conservatively
Safe preliminary checks
Work in order and stop whenever a step is not supported by the documentation for your model.
Record the code and model
- Photograph or write down the exact code or flashing pattern before clearing it.
- Confirm the full model number and Maytag owner manual before taking model-specific action.
Use only documented external checks
- Clean the removable dishwasher filter under running water if the manual identifies it as user-accessible.
- Check the visible drain hose for kinks or obvious restriction.
- If connected to a new disposer, confirm the knockout plug was removed by the installer or a qualified person.
Stop before internal work
- If the code remains after documented checks, request service.
- Do not remove panels, bypass switches, or access wiring, motors, pumps, controls, or heater circuits.
Actions not recommended
- Do not reach into wet areas while power is connected.
- Do not open electrical, motor, pump, heater, or control areas.
- Do not replace parts based only on the displayed code.
When to stop and request service
- F9 E1 returns after accessible filter and drain-hose checks.
- Standing water cannot be addressed safely.
- Pump, internal hose, wiring, or control diagnosis would be needed.
Documented source
Official information reviewed
Our summary is based on manufacturer support material and stays within the limits of that material.
Maytag Product Help
Dishwasher Error Codes - Reading
Source reviewed by Appliance Help HQ: August 17, 2026.
Appliance Help HQ is an independent informational site and is not affiliated with or endorsed by Maytag.
Think this information has changed? Report a correction.